Pedestals

TL1 slab support 10 mm stackable

The TL1 slab support 10 mm can be laid on any sealing foil. The very durable special plastic does not harden and reduces impact sound. TL1 are stackable and can be used for installation heights from 10 mm to over 200 mm.

Item no.	Height	Joint	Pcs./packing unit
TL1	10 mm	3 mm	100

stackable
edge solution
T-joint
fine leveling

TL2 block 30 mm stackable, only in use with TL1

The TL2 block 30 mm was designed to shorten work processes and save costs. The block must be
terminated at the top and bottom with TL1 and can therefore only be used from a structure height
of 50 mm.

Item no.	Height	Joint	Pcs./packing unit
TL2	30 mm	3 mm	52

stackable
edge solution
Structure heights

TL3 1 mm shim stackable

Easy leveling is possible using the TL3 1 mm shims. Deviating slab thicknesses, unevenness of the
substrate and all slope situations can be compensated for up to 10 mm per slab corner.

Item no.	Height	Pcs./packing unit
TL3	1 mm	4 x 500

fine leveling
mitigate / compensate for slope
laying of different slab thicknesses
leveling of unevenness from the substrate

TLGP Terra Level rubber granulate pad Alu laminated, 200 mm x 200 mm, 6 mm height

The Terra Level rubber granulate pads can be used in combination with TL1 10 mm or TL2 30 mm.
Thus, structure heights of 16 mm, 26 mm, 36 mm, etc. are realised and the number of TL3 1 mm
shims is reduced.

Item no.	Height	Pcs./packing unit
TLGP	6 mm	70

DVP bearing load distribution plate Joint 3 mm, diameter 200 mm

The bearing load distribution plate can be combined with TL1 and TL3. This provides a larger bearing
surface of 200 mm diameter.

Item no.	Height	Joint	Pcs./packing unit
DVP	4 mm	3 mm	100

Bearing load distribution for TL1 and TL2
Crushed stone support
Crushed stone support for edge
Crushed stone support suitable for TL3 1 mm shim